Description
Universal ski grip tape suitable for all types of snow. Temperature range: +5° to -20°C. Easy to use; one application lasts up to 250 km. The package contains 5 m of tape, enough for 2–3 pairs of skis.
Instructions for use
Also refer to the diagram on the package.
- Thoroughly clean the ski grip area (30–50 cm in the middle of the skis) with the grease remover, following the instructions supplied with it. Make sure the area is completely dry after cleaning.
- Sand the cleaned area with the sandpaper on the side of the product, side A (see the drawing on the package). Sand the entire grip area properly, first transversely and then longitudinally.
- Place the end of the Grip Tape at the beginning of the sanded grip area and press it down. Apply the lubricating strip of Grip Tape over the entire ski grip area.
- Cut the Grip Tape as follows: press your fingers onto the brake, side C. Lift the box upwards. Press side D against the lubricating strip. Twist the cut end twice.
- To prevent air bubbles from forming between the lubricant and the ski surface, firmly smooth the entire Grip Tape with side E.
- Remove the paper with a quick pull. If any air bubbles remain, replace the paper, smooth the tape again with side E, and remove the paper.
- Cool the skis outdoors. Do not touch the lubricated area with your hands or press the skis together, so that the lubricated areas do not touch.